4' Cold Work RR Anvil

I have found that a large section of RR rail is very useful for working sheet metal, light plate steel and other cold work such as bending and shaping, normally done on the vise, at risk of damaging the vise, or on a bench anvil, that is almost always too small.

To that end I used a 4' piece of RR rail to build a cold work bench complete with a good sized hammer rack. In addition to cold work, in a pinch it is also heavy and solid enough to do hot, smith work.

 To see the build click this link 4' Cold Work Anvil.


No comments:

Post a Comment